Now Days Because Of The Load-shading & Other Reasons Power Cuts Are Increased & Mains Supply Fails At Any Time Without Any Info ! It Causes The Lot Of Trouble ! The Solution Is Here For Domestic Users & also Industrial Sectors ! The Project Does
1. It senses the main supply failure and give starting pulse to
diesel generator through start solenoid.
2. If the generator dose not get started with the first attempt ,it will make two more attempts to start the D.G.set. When it fails to start with three attempts, it will sound an alarm with indication “ START FAIL”
3. Even if the engine starts normally but alternator dose not produce the required voltage, in that case “ALTERNATOR FAIL” signal will come
4. After the gen set has started normally and it has come to normal voltage ,it will switch on its breaker automatically (auto-on-load)
5. During normally running condition, if any fault occurs on the engine side, it will stop automatically with the respective fault and buzzer indication.
6. when the main supply get re-stored, it will change over to mains and switch off the D.G. set automatically.
7. It can be operated on both auto or manual mode.
2. If the generator dose not get started with the first attempt ,it will make two more attempts to start the D.G.set. When it fails to start with three attempts, it will sound an alarm with indication “ START FAIL”
3. Even if the engine starts normally but alternator dose not produce the required voltage, in that case “ALTERNATOR FAIL” signal will come
4. After the gen set has started normally and it has come to normal voltage ,it will switch on its breaker automatically (auto-on-load)
5. During normally running condition, if any fault occurs on the engine side, it will stop automatically with the respective fault and buzzer indication.
6. when the main supply get re-stored, it will change over to mains and switch off the D.G. set automatically.
7. It can be operated on both auto or manual mode.
Download The Project Idea From Below
0 comments:
Post a Comment